This PCB is designed to make MXCHIP's EMW3165 WiFi module breadboard-friendly. This board is entirely passive, meaning there are no additional compone...
A small board, top part is for use on breadboard with two 74HC595 in a DIP16 package. Board is designed for 1206 SMD resistors and SMD 1206 leds, or 5...
Safe-power shuts down the Operating System of your Raspberry in case of power failure, and turns the Raspberry back on if power comes back and is stab...
This is a slightly modified LED grid with the option of Trinket based control. Multiple boards may be daisy chained together. Trinket wiring not tes...
This is a replacement module for the PLA chip found in the Commodore 64 computer. It uses a CPLD chip rather than a EEPROM chip. A CPLD is way much fa...
12V Input, Arduino Nano control, place for A4988/DRV8825 stepper driver, 2xLM2596 DC-DC (1 should be 5V, second is your choice), 4x12V OUT, 4x12V PWM ...
This is a driver board for LED cubes. It was designed to drive an 8x8x8 RGB cube, so it has 3*64=192 channels for 8*8 RGB leds. You can cut the cuttab...
PCB for temperature difference thermostat. It is used to control heating based on temperature difference between inside and outside temperature. Infor...
